rivets

-

Rivets (click to enlarge)

• Blind Rivets
• Structural Blind Rivets
• Plastic Rivets
• Binder Rivets
• Solid Rivets
• Semi-Tubular Rivets
• Shoulder Solid Rivets
• Shoulder Semi-Tubular Rivets
• Offset Head Rivets
• Full Tubular Rivets

Comments

Post a Comment

Popular posts from this blog

The Difference Between Metal Sheet and Plate

-
The difference between a metal sheet and metal plate can be defined by thickness. If the thickness of the metal is ¼” (6mm) or more, then it is considered a plate. Plate thickness is typically measured in inches. If the thickness is less than ¼” (6mm), it is considered sheet. Sheet is typically measured in gauges. It is not uncommon however to see both metal sheet and plate additionally measured in mm.
Read more

Rubber seals used in irrigation structures

-
manufactures a wide range of rubber center-bulb, vertical and companion backstop water stop, music note, hump and flat dam gate seals. These are designed to retain water, prevent water penetration, or limit contaminated run off in civil engineering applications. The inherent elasticity and resilience of Rubber Concept gate seals allow it to retain its sealing effectiveness in situations where there are fluctuating movements caused by water pressure, traffic, subsidence or seismic movement. Unlike thermoplastic materials such as PVC, rubber seals remain dimensionally stable and functionally effective over many years whilst handling movement far in excess of the capability of PVC. Rubber seals provide superior resistance to chemical attack and heat degradation. Quality of Rubber Concept dam gate seals are very well accepted by various Government and private agencies. We have supplied numerous Gate seals for no. of dams across Gujarat and India. Our gate seals are also been accepte...
Read more

Fabricating of Steel Structures

-
Candidates must achieve TEN units made up of: ♦ all EIGHT of the Mandatory units plus ♦   MANDATORY UNITS - Candidate must achieve all EIGHT units Unit Title and Ref. Number Unit FSS1: power tools Shape components of fabricated steel structures by removal using hand and Unit FSS2: Prepare work areas for the fabrication of steel structures Unit FSS3: Prepare materials for the fabrication of steel structures Unit FSS4: Prepare equipment for the fabrication of steel structures Unit FSS5: Reinstate the work area after completing the fabrication of steel structures Unit CO1: Contribute to effective working relationships Unit CO2: Work safely and comply with emergency procedure Unit CO3: Deal with hazards in the work environment TECHNICAL OPTIONS - Candidates must achieve any TWO units. Unit Title and Ref. Number Unit FSS6: Assemble components of steel fabrications to meet specification Unit FSS7: Store steel structure fabrication related reso...
Read more